Hips and valleys: example from our work

Metal hips and valleys in Loznica

A hip is the outer edge where two roof slopes meet, and a valley is the inner corner where water runs in from both sides. These joints are the most vulnerable parts of a roof, so they are covered with sheet metal.

Profile cross-section

Valleys

More water runs through a valley than anywhere else on the roof. A metal valley has to be wide enough, with raised edges and the right overlap, so water does not spill over and get under the covering in a downpour.

Hips and ridges

Flashing hips and ridges seals the joint between slopes while keeping ventilation under the covering. The metal is bent to the roof angle and fixed so the wind cannot lift it.

When to replace them

If stains appear in the attic or on the ceiling along the roof corners, a worn or badly lapped valley is often the cause. Replacing a valley is a much smaller job than repairing rafters and ceilings.

Send an inquiry

Tell us where the building is and what needs doing. We will call to arrange a visit and measurements.

We only use your details to reply to you. Privacy details